NOTE: Please read all instructions carefully before using this product Table of Contents Safety Notice Hardware Pack Assembly Instruction Par
STEP 4 A.) Attach the pivot on Left Swing Handle (#30L) to the pivot on Main Frame (#35). B.) Thread the Swing Handle Shaft (#28) though Left Swing
STEP 5 A.) Attach the Swing Handle Connecting Rod (#48) to the open bracket on the bottom of the Left Swing Handle (#30L). B.) Secure them together w
STEP 6 A.) Attach the pivot on Right Swing Handle (#30R) to the pivot on Main Frame (#35). B.) Thread the Swing Handle Shaft (#28) through Right Sw
STEP-7 A.) Attach the Swing Handle Connecting Rod (#48) to the open bracket on bottom of the Right Swing Handle (#30R). B.) Secure them together with
STEP-8 A.) Thread the Left Pedal (#41L) counter clockwise into Left Crank (#44L). B.) Thread the Right Pedal (41R) clockwise into Right Crank (#44R).
STEP-9 A.) Remove the three Ø 5/8” Seat Flat Washers (#32) and M8 Seat Aircraft Nut (#33) from the Seat Pad (#31). B.) Attach the Seat Pad to the Sea
STEP-10 A.) Insert the Seat Post (#34) into the opening one Main Frame (#35). B.) Thread the Lock Knob (#63) through the hole on Seat Post to securel
EXPLODED DIAGRAM © IMPEX INC. 16
© IMPEX INC. 17 PARTS LIST PART NO. DESCRIPTION SPEC. QUANTITY 1 Computer TZ-2119 1 2 Upper Computer Wire 1 3 Computer Philips Screw
© IMPEX INC. 1837 Lower Computer Wire 1 38 Floor Level Adjustment Knob 2 39 Front Stabilizer 1 40 Stabilizer End Cap 4 41L Left Pedal
TABLE OF CONTENTS BEFORE YOU BEGIN...……. 1 IMPORTANT SAFETY N
© IMPEX INC. 19CARE, MAINTENANCE AND STORAGE 1. Inspect and tighten all parts each time you use the machine. Replace any worn parts immediately.
COMPUTER MODE Press “MODE” button, will automatically scan Time, Speed, RPM, Distance, and Calories, for every 6 seconds. Time Display the
© IMPEX INC. 21riginal purchaser. IMPEX's obligation under this Warranty is limited to replacing or repairing, at IMPEX's ption. commercia
© IMPEX INC. 2 IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever yo
WARNING LABEL PLACEMENT The Warning Labels and Caution Label shown here have been placed on the Rear Stabilizer, Main Frame. If the labels are mis
HARDWARE PACK NOTE: The following parts are not drawn to scale. Please use your own ruler to measure the size. © IMPEX INC. 4
COMPONENTS FOR ASSEMBLY © IMPEX INC. 5
ASSEMBLY INSTRUCTION Tools Required For Assembling the Machine: One Crossing Wrench and Allen Wrench, provided by manufacturer. NOTE: It is
STEP 2 A.) Connect the Upper Computer Wire (#2) from the Front Post to the Computer Wire from the Computer (#1). B.) Attach the Computer to the F
STEP 3 A.) Connect the Lower Computer Wire (#37) from Main Frame (#35) to the Upper Computer Wire (#2) from Front Post (#4). B.) Attach the Front
Comments to this Manuals