NOTE: Please read all instructions carefully before using this product Table of Contents Safety Notice Hardware Identifier Assembly Instructi
A.) Pull the Foot Support Lock Knob (#20) and then insert the Foot Support (#19) into the Foot Support Base (#47) from bottom. Release the Lock Knob
STEP 6 (See Diagram 6) A.) Attach the pivot on the bottom of Foot Lock Frame (#21) to the open bracket on the Foot Support (#19). Secure it with
STEP 7 (See Diagram 7) A.) Pull up the Foot Lock Knob (#23). Insert the Foot Lock Adjustment (#24) through the opening on Foot Lock (#21) to the ope
STEP 8 (See Diagram 8) A.) Push four Foam Rolls (#26) onto the tubes on the Foot Support (#19) and Inversion Foot Lock (#21). Plug four Foam Roll
STEP 9 (See Diagram 9) A.) Insert the Backrest Support (#34) into the back of Backrest Board (#28) into the Rear Vertical Frame (#22). Secure it wit
EXPLODED DIAGRAM 14
PARTS LIST KEY NO. DESCRIPTION Q’ty 1 Base Frame 1 2 Front Vertical Frame 1 3 M8 x 2 ½” Allen Bolt 2 4 Ø 5/8” Washer 24 5 M8 Airc
IMPEX® INC. LIMITED WARRANTY IMPEX Inc. ("IMPEX®") warrants this product to be free from defects in workmanship and material, under norma
TABLE OF CONTENTS BEFORE YOU BEGIN...……….. 1 IMPORTANT SAFETY NO
IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a pi
WARNING LABEL REPLACEMENT The warning label shown here has been placed on the Base Frame. If the label is missing or illegible, please call custome
HARDWARE PACK #3 M8 x 2 ½” Allen Bolt (Qty 2) #4 Ø 5/8” Washer (Qty 16) #5 M8 Aircraft Nut (Qty 5) #6 Ø ¾” Washer (Qty 5) #7 M10 Airc
ASSEMBLY INSTRUCTION Tools Required for Assembling the Machine: Two Adjustable Wrenches, two Allen Wrenches, and one Philips Screwdriver. NOTE: It
STEP 2 (See Diagram 2) A.) Two people to assemble this step are highly recommended. Do not tighten the Bolts until instructed to do so. B.) Attac
STEP 3 (See Diagram 3) A.) Two people to assemble this step are highly recommended. Do not tighten Nuts and Bolts until instructed to do so. B.) Attac
STEP 4 (See Diagram 4) A.) Attach the 1 5/8” Rubber Bumper (#29) to the Foot Support (#19). Attach the ¾” Rubber Bumper (#30) to the 1 5/8” Rubber Bu
Comments to this Manuals