NOTE: Please read all instructions carefully before using this product Table of Contents Safety Notice Hardware Pack Assembly Instruction Pa
DIAGRAM 2 9
STEP 3 (See Diagram 3) A.) Attach the Front Press Base (#8) to the Upper Frame (#1). Secure it with one 8 ½” Front Press Axle (#19), two Ø 1” x Ø 5/
DIAGRAM 3 11
STEP 4 (See Diagram 4) A.) Insert the Front Press Handle (#12) into the hole on Right Butterfly (#10) and Left Butterfly (#9). Secure each Handle with
STEP 5 (See Diagram 5) A.) Attach one Swivel Pulley Bracket (#17) to the open bracket on the back of Vertical Frame (#4). Secure it with one M10 x 2 ½
STEP 6 (See Diagram 6 & Cable Loop Diagram) A.) Attach the 126” Upper Cable (#32) to the front open bracket under the Upper Frame (#1). B.)
DIAGRAM 6 15
STEP 7 (See Diagram 7& Cable Loop Diagram) A.) Hook one end of the 98” Butterfly Cable (#34) to Right Butterfly (#10). B.) Draw the Cable towar
STEP 8 (See Diagram 8 & Cable Loop Diagram) A.) Attach the 164” Lower Cable (#33) to the open bracket on the Base Frame (#3). B.) Attach a
DIAGRAM 8 18
TABLE OF CONTENTS BEFORE YOU BEGIN...……….. 1 IMPORTANT SAFETY N
STEP 9 (See Diagram 9) A.) Attach Lat Bar (#14) to the Upper Cable (#32) with two Hooks (#53) and one 15-link Chain (#54) when doing Lat Pull exercise
Set up the Lock Combination A.) The combination is pre-set to 0-0-0 by the factory. B.) Turn the dials to 0-0-0 and aligned to the Combination Set Up
PARTS LIST KEY NO. DESCRIPTION Q’ty 1 Upper Frame 1 51 Selector Stem 1 2 Rear Stabilizer 1 52 Ankle Strap 1 3 Base Frame 1
MWM981 WEIGHT RESISTANCE CHART Weight Plate Leg Developer Front Press Butterfly Lat Pull Low Pulley 1 30 31 15 3
IMPEX® INC. LIMITED WARRANTY IMPEX Inc. ("IMPEX®") warrants this product to be free from defects in workmanship and material, under norma
IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a piec
WARNING LABEL REPLACEMENT The warning labels shown here have been placed on the Rear Stabilizer and Upper Frame. If the labels are missing or illeg
HARDWARE PACK NOTE: The following parts are not drawn to scale. Please use your own ruler to measure the size. 4
HARDWARE PACK NOTE: The following parts are not drawn to scale. Please use your own ruler to measure the size. 5
ASSEMBLY INSTRUCTION Tools Required for Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches. NOTE: It is strongly recommended that th
DIAGRAM 1 7
STEP 2 (See Diagram 2) A.) Attach the holes on the Upper Frame (#1) onto the Guide Rods (#11). Place the Upper Frame onto the Vertical Frame (#4
Comments to this Manuals