GB-7000AP Recumbent Bike IMPEX FITNESS PRODUCTS 14777 Don Julian Rd., City of Industry, CA 91746 Tel: (800) 999-8899 F
STEP 13: Pull the hand pulse sensor wire out from the end of the aluminum track on the MAIN FRAME (#1). STEP 14: Attach the REAR HANDL
STEP 17: Push two RUBBER CUSHIONS (#10) into both side of aluminum track on the MAIN FRAME (#1). STEP 18: Plug the END CAP (#17) into th
COMPUTER INSTRUCTION MANUAL A. POWER UP: 1. Install four UM-2 or R14 batteries into the battery case on the back of monitor.
1.DETAIL OPERATION OF PROGRAM 1 TO PROGRAM 10: A. To enter the initial mode, press and hold the START / STOP key for 2 seconds. B. Press + or - key
D. TECHNICAL NOTES: 1. The PULSE rate will be displayed after detecting 4 stable pulse signals. 2. Each pulse is a signal and will be accompanied wi
FITNESS TIPS CONSULT YOUR PHYSICIAN Before using this product, please consult your personal physician for a complete physical examination. Your doct
Exercising in your target zone How fast should your heart beat during aerobic exercise? Fast enough to reach and stay in its “target zone”, a range
Side stretches Open your arms to the side and continue lifting them until they are over your head. Reach your right arm as far upward toward the ce
Calf/Achilles stretch Lean against a wall with your left leg in front of the right and your arms forward. Keep your right leg straight and th
IMPEX INC. LIMITED WARRANTY IMPEX Inc. ("IMPEX") warrants this product to be free from defects in workmanship and material, under nor
TABLE OF CONTENTS BEFORE YOU BEGIN...1 IMPORTA
IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate
PARTS DRAWING: NO. DESCRIPTION Q'TY NO. DESCRIPTION Q'TY 1 MAIN FRAME 1 PCE 11 PEDAL STRAP (L) 1 PCE 2 FRONT H
SCREW PACK & TOOLS: Following are the nuts and bolts needed to assembly the machine. Before start assembling, please check the quantity to make
ASSEMBLY: STEP 1: Attach the REAR STABILIZER (#15) to the MAIN FRAME (#1). Securely tighten it with two CARRIAGE BOLTS, WASHERS AND NUTS.
STEP 4: Use the screwdriver to remove the two Bottle Frame screws on the COMPUTER POST (#3). STEP 5: Attach the BOTTLE FRAME (#19) onto t
STEP 7: Connect the computer sensor wire and hand pulse sensor wire to the jack on the back of the COMPUTER. Attach the COMPUTER (#4) onto the COMPU
STEP 10: Slide the SEAT BRACKET (#5) onto the aluminum track on the MAIN FRAME (#1). Attach the BACKREST BOARD (#7) to the SEAT BRACKET at the front.
Comments to this Manuals