Impex GD-600 Owner's Manual

NOTE: Please read all instructions carefully before using this product Table of Contents Safety Notice Hardware Pack Assembly Instruction Pa

Step 5 (See Diagram 5) A.) Insert the Sun Shade Support Frame (#13) into the Long Support Cover Caps (#17). DIAGRAM 5 9

Step 6 (See Diagram 6) A.) Cover all M8 x 5/8” Allen Bolts (#24) and Cap Washers (#2) with sixteen Cover Caps (#3). DIAGRAM 6 10

OPERATION 1. Place the Rocking Hammock on flat surface. 2. Lay in the middle of the Hammock Body only, and place head on the pillow. 3. Gently

EXPLODED DIAGRAM 12

Parts list KEY NO. DESCRIPTION Q’ty 1 Spacer 2 2 Cap Washer 16 3 Cover Cap 16 4 Hammock Base Frame 2 5 Left Long Support

IMPEX® INC. LIMITED WARRANTY IMPEX INC ("IMPEX®") warrants this product to be free from defects in workmanship and material, under normal

TABLE OF CONTENTS BEFORE YOU BEGIN... 1 IMPORTANT SAFETY NOTICE

IMPORTANT SAFETY NOTICE Please read the entire manual before assembling or operating the equipment. In particular, note the following safety prec

WARNING LABEL PLACEMENT The Warning Label shown here has been placed on the Stabilizer Frame. If the label is missing or illegible, please call cu

HARDWARE IDENTIFIER Part# Description Identifier

ASSEMBLY INSTRUCTION Tool Required for Assembling the Machine: #5 Allen Wrench NOTE: It is strongly recommended that two or more people assemble th

Step 2 (See Diagram 2) A.) Do not tighten Bolts until instructed to do so. B.) Insert a Hammock Body Support Tube (#12) through the sleeve next to

Step 3 (See Diagram 3) A.) Insert the Right Short Support (#8) into right opening on the Hammock Base Frame (#4). B.) Insert the Hammock Body Support

Step 4 (See Diagram 4) A.) Insert the Support Rod (#21) and Sun Shade Rod (#20) through the sleeve on the Sun Shade (#14). B.) Insert each end of th