NOTE: Please read all instructions carefully before using this product Table of Contents Safety Notice Hardware Identifier Assembly Instructi
DIAGRAM 1 9
STEP 2 (See Diagram 2) A.) Slide 14 Weight Plates (#33) onto the Guide Rods. Make sure the deep groove on the Weight Plates all facing the front
DIAGRAM 2 11
STEP 3 (See Diagram 3) A.) Attach the Seat Support (#8) to the Vertical Frame (#4). Secure it with two M10 x 2 ½” Carriage Bolts (#65), one 4 ¾” x 2”
STEP 4 (See Diagram 4) A.) Attach two Ø 1” Bushings (#44) to the holes on the Upper Frame (#5). Attach the Front Press Base (#11) to the two Bushi
CABLE LOOP DIAGRAM 14
STEP 5 (See Diagram 5 & Cable Loop Diagram) A.) Attach the 153” Upper Cable (#34) to the opening at the front of the Upper Frame (#5). Note:
DIAGRAM 5 16
STEP 6 (See Diagram 6 & Cable Loop Diagram) A.) Attach one end of the 125” Butterfly Cable (#35) to the hook on the Right Butterfly (#13). B.)
DIAGRAM 6 18
TABLE OF CONTENTS BEFORE YOU BEGIN...……….. 1 IMPORTANT SAFETY NO
STEP 7 (See Diagram 7 & Cable Loop Diagram) A.) Attach the 131” Lower Cable (#36) to the opening on the bottom of the Leg Developer (#9). B.
DIAGRAM 7 20
PARTS LIST KEY NO. DESCRIPTION Q’ty 1 Main Base Frame 1 2 Rear Base Frame 1 3 Vertical Support Frame 1 4 Vertical Frame 1 5 Upper Frame 1 6
22
IMPEX® INC. LIMITED WARRANTY IMPEX Inc. ("IMPEX®") warrants this product to be free from defects in workmanship and material, under norma
IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a p
WARNING LABEL REPLACEMENT The warning labels shown here have been placed on the Rear Base and Upper Frame. If the labels are missing or illegible, p
HARDWARE PACK NOTE: The following parts are not drawn to scale. Please use your own ruler or scale to measure the size. 4
HARDWARE PACK NOTE: The following parts are not drawn to scale. Please use your own ruler or scale to measure the size. 5
HARDWARE PACK NOTE: The following parts are not drawn to scale. Please use your own ruler or scale to measure the size. 6
HARDWARE PACK NOTE: The following parts are not drawn to scale. Please use your own ruler or scale to measure the size. 7
ASSEMBLY INSTRUCTION Tools Required for Assembling the Machine: Two Adjustable Wrenches, two Allen Wrenches, and one Philips Screwdriver. NOTE: It
Comments to this Manuals