NOTE: Please read all instructions carefully before using this product Table of Contents Safety Notice Hardware Identifier Assembly Instructi
STEP 3 (See Diagram 3) A.) Attach the Leg Developer (#33) to the open bracket on the Main Frame (#27). Secure it with one M10 x 3 1/8” Allen Bolt
STEP 4 (See Diagram 4) A.) Attach the Arm Curl Pad (#37) to the Arm Curl Stand (#32). Secure it with two M8 x ¾” Allen Bolts (#84) and two ∅ ¾” W
STEP 5 (See Diagram 5) A.) Note: Do not tighten the Nuts and Bolts until instructed to do so. B.) Attach the top of Left Support (#2) to an Upright
STEP 6 (See Diagram 6) A.) Attach the Rear Vertical Frame (#9) onto the Rear Base (#8). Secure it with two M10 x 2 ½” Carriage Bolts (#74), Ø ¾” Wa
DIAGRAM 6 13
CABLE LOOP DIAGRAM 14
STEP 7 (See Diagram 7 & Cable Loop Diagram) A.) Attach the 113 7/8” Upper Cable (#24) to the front opening on the Upper Frame (#11). Make sure the
STEP 8 (See Diagram 8 & Cable Loop Diagram) A.) Attach the 58 1/8” Lower Cable (#25) to the lower opening on the bottom of Front Vertical Frame (
STEP 9 (See Diagram 9) A.) Attach a Weight Post (#20) to the Right Support (#3). Secure it with a M10 x ¾” Allen Bolt (#81) and Ø ¾” Washer (#69).
TABLE OF CONTENTS BEFORE YOU BEGIN... 1 IMPORTANT SAFETY NOTIC
RACK EXPLODED DIAGRAM 19
PARTS LIST KEY NO. DESCRIPTION Q’ty 1 Upright Beam 2 51 1 ¾” Square End Cap 5 2 Left Support 1 52 2” Square End Cap 2 3 Right Supp
IMPEX® INC. LIMITED WARRANTY IMPEX Inc. ("IMPEX®") warrants this product to be free from defects in workmanship and material, under norma
IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a p
WARNING LABEL REPLACEMENT The warning labels shown here have been placed on the Rear Stabilizer, and Upper Frame. If the labels are missing or ille
HARDWARE PACK 4
HARDWARE PACK 5
HARDWARE PACK 6
ASSEMBLY INSTRUCTION Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches NOTE: It is strongly recommended this machi
STEP 2 (See Diagram 2) A.) Attach the two side-holes on bottom of Backrest Supports (#30) to the pivot on the Main Frame (#27). Secure it with one
Comments to this Manuals