NOTE: Please read all instructions carefully before using this product Table of Contents Safety Notice Hardware Pack Assembly Instruction Par
STEP 4 (See Diagram 4) A.) Remove the three Ø 5/8” Washers (#12), three Ø 3/8” Lock Washers (#13), and three M8 Aircraft Nuts (#14) from the Seat (#
STEP 5 (See Diagram 5) A.) Thread the Left Pedal (#9) counterclockwise into the Crank (#25). B.) Thread the Right Pedal (#10) clockwise into the Cr
EXPLODED DIAGRAM 11
PARTS LIST KEY NO. DESCRIPTION QUANTITY 1 Main Frame 1 2 Front Stabilizer 1 3 Rear Stabilizer 1 4 Front Post 1 5 Handle 1 6
COMPUTER AUTO START / STOP When exercise starts, the monitor will automatically turn on and display the progress. When exercise stops, the monitor w
EXERCISE INSTRUCTIONS Using your MAGNETIC BIKE will provide you with several benefits, it will improve your physical fitness, tone muscle and in co
3. The Cool Down Phase This stage is to let your Cardio-vascular System and muscles wind down. This is a repeat of the warm up exercise e.g. reduce
IMPEX® INC. LIMITED WARRANTY IMPEX Inc. ("IMPEX®") warrants this product to be free from defects in workmanship and material, under normal
TABLE OF CONTENTS BEFORE YOU BEGIN...…. 1 IMPORTANT SAFETY NOTICES..
IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a
WARNING LABEL PLACEMENT The Warning Label shown here has been placed on the Rear Stabilizer. If the label is missing or illegible, please call custo
HARDWARE PACK No. Description Identifier Q’ty 12 Ø 5/8” Washer 2 15 M8 x 2 ½” Carriage Bolt 2 16 Ø 7/8” Curved Washer 6 17 M8 Acorn Nut 2 1
PRE-ASSEMBLY CHECK LIST PART NO. DESCRIPTION Q’TY 01 Main Frame 1 02 Front Stabilizer 1 03 Rear Stabilizer 1 04 Front Post
ASSEMBLY INSTRUCTION NOTE: It is strongly recommended that two or more people assemble this machine to avoid possible injury. STEP 1 (See Diagram1)
STEP 2 (See Diagram 2) A.) Note: In order to hold the Front Post (#4) while connecting the cables and wires, extra help may be needed. B.) Attac
STEP 3 (See Diagram 3) A.) Attach the Handle (#5) to the Front Post (#4). Secure it with two M8 x 1 1/8” Screws (#26). B.) Connect Upper Computer
Comments to this Manuals