NOTE: Please read all instructions carefully before using this product Table of Contents Safety Notice Hardware Identifier Assembly Instructi
DIAGRAM 1 9
STEP 2 (See Diagram 2) A.) Attach the Rear Vertical Beam (#38) onto the Cross Brace (#36). Attach the Weight Glide Post (#34) to the Rear Vertic
DIAGRAM2 11
STEP 3 (See Diagram 3) A.) Attach the Butterfly Base (#39) and Butterfly Pulley Bracket (#44) to the Rear Vertical Beam (#38). Align the holes and
STEP 4 (See Diagram 4) A.) Note: Help of another person is strongly recommended for this step. Place the Weight Lifting Sleeve (#48) in between the
CABLE LOOP DIAGRAM 14
STEP 5 (See Diagram 5 & Cable Loop Diagram) A.) Attach a 124” Cable (#60) to the front opening on the Upper Frame (#37). Attach a Pulley (#8
DIAGRAM 5 16
STEP 6 (See Diagram 6 & Cable Loop Diagram) A.) Attach one end of the 79” Butterfly Cable (#61) to the clip on the Left Butterfly (#40). Draw th
STEP 7 (See Diagram 7 & Cable Loop Diagram) A.) Attach one 124” Cable (#60) to the lower opening on the Rear Vertical Beam (#38). Attach a Pulle
TABLE OF CONTENTS BEFORE YOU BEGIN... 1 IMPORTANT SAFETY NOT
STEP 8 (See Diagram 8) A.) Attach the Front Post (#3) to the Front Stabilizer (#17). B.) Secure it with three M10 x 5/8” Allen Bolts (#90) and ∅
STEP 9 (See Diagram 9) A.) Attach the Main Seat Support (#1) to the Rear Stabilizer (#4). Secure it with two M10 x 2 3/8” Carriage Bolts (#100), one
STEP-10 (See Diagram 10) A.) Attach the Leg Developer Holder (#2) to the Main Seat Support (#1). Secure it with one M10 x 5/8” Allen Bolt (#90) and
STEP-11 (See Diagram 11) A.) Insert two ؽ” Bushings (#113) into the holes on the Seat Bracket (#5) and align the holes to the pivot on the Main Seat
STEP-12 (See Diagram 12) A.) Place the Seat Pad (#8) onto the Seat Bracket (#5). Secure it with four M8 x 1 5/8” Allen Bolts (#99) and Ø5/8” Washers
STEP-13 (See Diagram 13) A.) Insert three Foam Tubes (#16) halfway through the holes on Leg Developer Holder (#2) and Leg Developer (#12). B.) Push
SMITH MACHINE EXPLODED DIAGRAM 25
PARTS LIST KEY NO. DESCRIPTION Q’ty 1 Main Seat Support 1 59 1 5/8” x ¾” End Cap 2 2 Leg Developer Holder 1 60 124” Cable 2 3 Front
IMPEX® LIMITED WARRANTY IMPEX® warrants this product to be free from defects in workmanship and material, under normal use and service conditions,
IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a pi
WARNING LABEL REPLACEMENT The warning labels shown here have been placed on the Cross Brace, Rear Stabilizer, and Upper Frame. If the labels are mi
HARDEWARE PACK 4
HARDEWARE PACK 5
HARDEWARE PACK 6
HARDEWARE PACK 7
ASSEMBLY INSTRUCTION Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches. NOTE: It is strongly recommended two or mo
Comments to this Manuals