Impex SM-3000 Owner's Manual

NOTE: Please read all instructions carefully before using this product Table of Contents Safety Notice Hardware Identifier Assembly Instructi

STEP 6 (See Diagram 6) A.) Attach one end of the 77” Butterfly Cable (#65) to the Right Butterfly Arm. Secure it with a M10 x 1” Allen Bolt (#32), t

STEP 7 (See Diagram 7) A.) Attach the 132” Upper Cable (#25) to the top of the Upper Frame (#21). Make sure the ball on the Cable is underneath

DIAGRAM 7 11

12

PARTS LIST KEY NO. DESCRIPTION Q’ty 1 Left Base Frame 1 51 Butterfly Backrest Boar 1 2 Right Base Frame 1 52 M8 x 2 ½” Allen Bolt 2 3

MULTIPURPOSE BENCH ASSEMBLY INSTRUCTION Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches NOTE: It is strongly rec

STEP 2 (See Diagram 2) A.) Attach two Bushings (#23) to each Seat Support Frames (#6). B.) Attach one Backrest Support (#7) to the Seat Support F

STEP 3 (See Diagram 3) A.) Align the holes on the two Backrest Supports (#7) to the pivot on the Sliding Block (#9). Secure them with one M10

STEP 4 (See Diagram 4) A.) Attach the Seat Incline Support Bracket (#8) to the Main Frame (#1). Secure it with one M10 x 4 3/4” Allen Bolt (#34),

STEP 5 (See Diagram 5) A.) Place the Seat Pad (#14) onto the Seat Support Frames (#6). Align the holes and secure it with four M8 x 2” Allen Bolt

TABLE OF CONTENTS BEFORE YOU BEGIN... 1 IMPORTANT SAFETY NOTI

STEP 6 (See Diagram 6) A.) Insert the Leg Developer Holder (#4) into the opening in front of the Seat. Secure it with a Lock Knob underneath the S

20

MULTIPURPOSE BENCH PARTS LIST KEY NO. DESCRIPTION Q’ty 1 Main Frame 1 2 Front Stabilizer 1 3 Rear Stabilizer 1 4 Leg Developer Holder 1 5 Leg

IMPEX INC. LIMITED WARRANTY IMPEX Inc. ("IMPEX") warrants this product to be free from defects in workmanship and material, under normal u

IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a

3

SMITH MACHINE ASSEMBLY INSTRUCTION Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches NOTE: It is strongly recommend

STEP 2 (See Diagram 2) A.) Slide the Safety Stop Frame (#12) onto the Front Vertical Beam (#9) and Guide Rod (#16) from the top. Drop the Stop Fra

STEP 3 (See Diagram 3) A.) Attach the Lat Bar Frame (#23) to the Lat Bar Base (#10). Secure it with two M10 x 2 ½” Allen Bolts (#22), four ∅ ¾” Wa

STEP 4 (See Diagram 4) A.) Attach the Upper Frame (#21) to the top of the Front Top Beam (#19). Secure it with one M10 x 3” Allen Bolt (#4), two

STEP 5 (See Diagram 5) A.) Attach the Backrest Board (#51) to the Rear Vertical Beam (#8). Secure it with two M8 x 2 ½” Allen Bolts (#52) and ∅