Impex SM-3000 Owner's Manual download pdf (Page 11)

STEP 7 (See Diagram 7)

A.) Attach the 132” Upper Cable (#25) to the top of the Upper Frame (#21). Make sure

the ball on the Cable is underneath the Frame. Attach a Pulley (#38) to the bracket

then secure it with one M10 x 1 ¾” Allen Bolt (#24), two ∅ ¾” Washers (#5) and

one M10 Aircraft Nut (#6).

B.) Continue drawing the Cable (#25) towards the back of the machine. Install another

Pulley.

C.) Draw the Cable (#25) downward. Install another Pulley (#38) and a Double Floating

Pulley Bracket (#50). Secure it with a M10 x 1 ¾” Allen Bolt (#24), two ∅ ¾”

Washers (#5) and one M10 Aircraft Nut (#6). Let the Bracket hanging for now.

Note: There are four holes on the Pulley Bracket. The purpose of these holes is to

adjust the tightness of the cable loop system. After finish installing the cables,

check the tightness of the cables. If the cables are too loose, shorten the distance

between the two pulleys by installing the upper pulley to a lower hole.

D.) Pull the Cable (#25) upward back to the Upper Frame (#21). Install another Pulley.

E.) Draw the Cable (#25) downward towards the Weight Post (#31). Secure the end of

the Cable to the Post with a M10 x 1” Allen Bolt (#32), two ∅ ¾” Washers (#5), and

one M10 Aircraft Nut (#6).

F.) Attach the 111” Lower Cable (#64) to the bottom of the Rear Vertical Beam (#8).

Install a Pulley (#38) to the slotted hole. Push two Pulley Bushings (#63) into the

holes from both sides on the Beam. Secure it with one M10 x 2 ¾” Allen Bolt (#62),

two ∅ ¾” Washers (#5) and one M10 Aircraft Nut (#6).

G.) Draw the Cable (#64) to the Lat Bar Base (#10). Install another Pulley.

H.) Pull the Cable (#64) upward to the Double Floating Pulley Bracket (#50) previously

installed in Step C above. Install another Pulley.

I.) Continue drawing the Cable (#64) to the Bracket on the Rear Vertical Beam (#8).

Install a Pulley.

J.) Pull the Cable upward to the Single Floating Pulley Bracket (#49) previously install

in Step 6. Secure it with a M10 x 1” Allen Bolt (#32), two ∅ ¾” Washers (#5) and

one M10 Aircraft Nut (#6).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

No comments

Impex SM-3000 Owner's Manual Page 11